WiNRADiO Future of radio
   

  WR-G527e Detailed Technical Specifications

WR-G527e/TM Tuner Module

Input frequency range0.01 - 30 MHz (direct input section)
20-3000 MHz (heterodyne section)
Tuning resolution10 Hz
Output frequency70 MHz
Output bandwidth22 MHz
Gain30 dB typ.
Noise figure10 dB typ. @ 100 MHz
Internal spuriiTyp. less than -107 dBm of equivalent antenna input level*
IF rejection>60 dB
Maximum input level+10 dBm
Attenuation control0-30 dB switchable front-end attentuator in 2 dB steps,
20 dB switchable attenuator in IF path
IP30 dBm typ. @ 10 kHz spacing (preamp off)
Input impedance50 ohm (SMA connector) for each channel
Output impedance50 ohm (SMA connector) for each channel
Amplitude ripple3 dB typ.
Phase ripple3 degrees typ.
Channel-to-channel isolation>80 dB
Operating voltage12 V DC ±5%
Power consumption8 W typ.
Dimensions150 x 90 x 30 mm (5.9" x 3.5" x 1.2")
Weight330 g (11.6 oz)
Operating temperature-10 to +60 C
Humidity20-90% non-condensing

 

WR-G527e/RMF Reference Oscillator and Distribution Module

Total oscillator phase noise-115 dBc/Hz @ 10 kHz
Tuning speed5 ms typ.
Settling speed0.8 ms / MHz typ.
Frequency stability0.01 ppm
Operating voltage12 V DC ±5%
Power consumption12 W typ.
Dimensions150 x 90 x 45 mm (5.9" x 3.5" x 1.8")
Weight660 g (23.3 oz)
Operating temperature-10 to +60 C
Humidity20-90% non-condensing

 

* As a result of the heterodyne process, a small number of spurii exist on certain frequencies (approx 6 frequencies in the entire 20-3000 MHz range), which are above the typical -107 dBm level. No spurii exceed the -90 dBm level.

Due to continuous product improvement, specifications are subject to change without notice.


 WR-G527e General Information
 WR-G527e Software Support
 WR-G527e Experimental Platform
 WR-G526e/DSP Back-End
 How to Order

Interested? Please use our Rapid Response Form to register your interest in this product, or to request more information.